How To Replace Crankshaft Position Sensor Toyota Camry 3.0L V6

Difficulty: Intermediate · About 35 min · Toyota Camry

Replace the crankshaft position sensor on the 3.0L V6 by freeing belt access, changing the sensor, and routing the belt correctly afterward.

Steps

1. Disconnect power and clear access

   Disconnect the negative battery cable. Relieve belt tension and move the belt aside, then lift the coolant reservoir out of its retainer to expose the sensor area.

2. Remove the old sensor

   Release the sensor connector without pulling on its wires. Remove the retaining fastener and withdraw the sensor from its mounting point.

3. Install the replacement sensor

   Seat the new sensor fully and secure it with its fastener. Reconnect the electrical plug until its lock engages.

4. Restore belt routing and power

   Route the serpentine belt using the underhood diagram, restore tension, and return the reservoir to its holder. Reconnect the battery and confirm the engine starts without a warning light.

Check your vehicle’s repair manual for exact specifications and fit.