How to Replace Front Power Window Motor 05-10 Volkswagen Jetta
Difficulty: Intermediate · About 60 min · Volkswagen Jetta
Replace the front power window motor on a 2005–2010 Volkswagen Jetta after removing the inner door trim, then reconnect the motor and verify operation before closing the door.
Tools you will need
- Flat Blade Screwdriver
- T20 Driver
- T30 Bit
- Ratchet
- T25 Torx Driver
Parts and supplies
- Front power window motor
Steps
Remove the interior door panel
Pry up the window switch panel and remove the pull handle and inner handle trim. Remove the T30 and T20 screws, release the panel clips, lift the panel away, and disconnect its latch cables and wiring.
Remove the window motor
Disconnect the motor wiring plugs and remove the three T25 retaining screws. Pull the motor straight away from the regulator drive without disturbing the glass or regulator alignment.
Install the replacement motor
Position the replacement motor against the regulator and start its retaining screws by hand. Tighten the screws evenly and reconnect the motor wiring plugs.
Reinstall the panel and test
Reconnect the latch cables and electrical leads, then align the door panel and press its clips into place. Reinstall the handle and trim screws, reconnect the switch panel, and test the window through its full travel.
Check your vehicle’s repair manual for exact specifications and fit.