How to Replace Power Door Lock Switch 05-10 Volkswagen Jetta
Difficulty: Intermediate · About 35 min · Volkswagen Jetta
Replace the power door lock switch on a 2005–2010 Volkswagen Jetta by removing the door panel, transferring the switch to the handle, and reconnecting latch and speaker wiring.
Tools you will need
- T20 Torx driver
- T30 Torx driver
- Flat blade screwdriver
Parts and supplies
- Power door lock switch
Steps
- Remove the interior door panel
Lift the window switch panel and remove the handle and lower-panel Torx screws. Release the panel clips, lift the panel away, and disconnect the latch cable, speaker lead, and other switch harnesses.
- Remove the old lock switch
Disconnect the switch wiring and remove the two T20 handle screws. Release the handle tabs and push the assembly out, then free the old lock switch from the handle.
- Install the replacement switch
Press the new switch into the handle until its retaining tabs engage. Reinstall the handle in the door panel, install its two screws, and reconnect the switch harness.
- Reassemble and test door locks
Reconnect the trunk switch, speaker wiring, and latch cable. Hang the panel on the door, press its clips in, reinstall all Torx screws and trim, then test the lock and handle.
Check your vehicle’s repair manual for exact specifications and fit.