How to Replace Power Window Motor 90-09 Lincoln Town Car
Difficulty: Intermediate · About 50 min · Lincoln Town Car
Replace the window motor on a Lincoln Town Car by securing door access, testing the motor before trim installation, and restoring the moisture barrier.
Tools you will need
- Flat Blade Screwdriver
- T20 Driver
- T30 Driver
- Phillips Head Screwdriver
- Painter's Tape
Parts and supplies
- Power window motor
Steps
Remove the door panel
Pry up the switch panel and disconnect its harness. Remove the handle and panel screws, release the trim clips, lift the panel away, and peel back the moisture barrier.
Remove the old motor
Unplug the motor and remove its retaining screws while supporting the assembly. Withdraw the motor carefully from the door cavity and separate it from the gear assembly.
Install and test the replacement
Attach the replacement motor to the gear assembly and start each screw by hand. Reconnect the switch temporarily and cycle the window to confirm smooth operation.
Restore door trim
Disconnect the temporary switch connection, return the moisture barrier to its original position, and reconnect the courtesy light. Refit the panel, handle, screws, and switch harness.
Check your vehicle’s repair manual for exact specifications and fit.