How to Replace Air Filter and Snow Screen 14-19 Audi SQ5
Difficulty: Beginner · About 30 min · Audi Sq5
Replace the engine air filter and snow screen on a 2014–2019 Audi SQ5, checking the filter seal and routing the intake hose so it sits fully seated after service.
Tools you will need
- Flat Blade Screwdriver
- Vacuum
- T15 Torx Driver
- Trim Tool Set
- T25 Torx Driver
Parts and supplies
- Engine air filter
Steps
- Open the air-filter housing
Remove the housing screws and release the intake-hose clips. Separate the hose from the air box, lift the cover, and remove the fasteners holding the filter in its frame.
- Install the new filter
Check that the replacement filter seal is seated correctly, then fit it into the housing and secure its fasteners. Vacuum loose debris from the air box without pushing dirt into the intake opening.
- Remove the snow screen
Press the center pins of the grille-shield clips and release them carefully. Lift the shield and slide the snow screen down and out of its air-duct channel.
- Reinstall the screen and verify the intake
Slide the snow screen back into its channel, seat the shield, and reinstall its clips. Reconnect the intake hose, engage its clips, and tighten the housing screws evenly.
Check your vehicle’s repair manual for exact specifications and fit.