How to Replace Brake Kit 92-01 Toyota Camry

Difficulty: Beginner · About 60 min · Toyota Camry

Replace the front brake pads and rotors on a 1992–01 Toyota Camry, inspecting caliper slides and pumping the pedal before a cautious road test.

Steps

1. Lift and remove the wheel

   Remove the hubcap and loosen the lug nuts while the car is on level ground. Raise and support it securely, then remove the wheel.

2. Remove the caliper and rotor

   Remove the caliper bolts and support the caliper with a wire tie. Take out the pads, unbolt the caliper bracket, and pull the rotor from the hub.

3. Install the replacement rotor

   Clean the new rotor's friction surfaces and place it on the hub. Refit the caliper bracket and tighten its fasteners to the vehicle's specification.

4. Fit new pads and caliper

   Check that the caliper pins move freely. Seat the new pads in the bracket, compress the piston with a suitable clamp, and reinstall the caliper with its bolts tightened to specification.

5. Reinstall the wheel

   Mount the wheel and start all lug nuts by hand. Lower the vehicle and tighten the nuts to specification in a star pattern, then replace the hubcap.

6. Pump the pedal and check braking

   Before moving the car, pump the brake pedal until it feels firm. Verify braking at low speed in a clear area, then follow the pad and rotor manufacturer's bedding guidance.

Check your vehicle’s repair manual for exact specifications and fit.