How to Replace Front Brakes 95-02 Ford Ranger
Difficulty: Intermediate · About 100 min · Ford Ranger
Replace front pads and rotors on a 1995–2002 Ford Ranger. Support the caliper, clean the pad hardware, and tighten brake and wheel fasteners to the exact vehicle specification before testing carefully.
Tools you will need
- Floor jack
- Jack stands
- 19mm socket
- 15mm socket
- 13mm socket
- Ratchet
- Wire brush
- Brake parts cleaner
- Torque wrench
Parts and supplies
- Front brake pads
- Front brake rotors
Steps
Lift and remove the wheel
Loosen wheel nuts while the truck is on the ground, raise it at approved points, and secure it on jack stands. Remove the wheel and inspect the pads and rotor.
Remove the caliper and rotor
Remove the caliper fasteners and ease the piston back enough to clear the rotor. Support the caliper without loading its hose, then remove the bracket and rotor.
Prepare the replacement parts
Clean the bracket and retaining clips with a wire brush, and clean the new rotor with brake cleaner. Retract the piston with a suitable clamp and keep lubricant off friction surfaces.
Install the brakes and wheel
Fit the rotor, bracket, and new pads, applying only brake-approved lubricant to contact points. Reinstall the caliper and wheel, tightening hardware to vehicle specification.
Restore pedal feel and test
Lower the truck and pump the brake pedal until it feels firm. Check for leaks or warnings and test at low speed in a safe area before normal driving.
Check your vehicle’s repair manual for exact specifications and fit.