How to Replace Mirror Switch 99-05 Volkswagen Jetta and Golf
Difficulty: Intermediate · About 45 min · Volkswagen Jetta
Replace the power mirror switch on a 1999–2005 Volkswagen Jetta or Golf by removing the driver door panel and releasing the switch tabs.
Tools you will need
- Flat blade screwdriver
- T20 Torx driver
- Phillips screwdriver
Parts and supplies
- Power mirror switch
Steps
Remove the door panel
Switch off the ignition and lift out the pull and window-switch trim. Unplug the switch harness, remove the door-panel fasteners, and carefully release the perimeter clips.
Disconnect the panel
Lift the panel from the window ledge and release the latch cable and remaining connectors. Place the panel on a padded surface to avoid scratching its finish.
Replace the mirror switch
Release the three retaining tabs from behind the panel and push the old switch out. Press the replacement into the opening until all tabs lock.
Reinstall the panel
Reconnect each wiring plug and the latch cable, securing the cable clip. Hang the panel on the sill, press its clips in, and reinstall its screws and switch trim.
Test the mirror controls
Reconnect the battery if it was disconnected, then test left and right mirror adjustment. Confirm all door switches and latch operation before closing the door.
Check your vehicle’s repair manual for exact specifications and fit.