How to Replace Exterior Door Handle 01-04 Toyota Sequoia
Difficulty: Intermediate · About 80 min · Toyota Sequoia
Replace the exterior door handle on a 2001–2004 Toyota Sequoia, transferring the lock cylinder and latch rod while protecting the door water shield and electrical connectors.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- Putty Knife
- 8mm Wrench
- 10mm Socket
- Ratchet
- Needle nose pliers
Parts and supplies
- Exterior door handle
Steps
Disconnect the battery and remove the panel
Disconnect the negative battery cable. Release the switch, courtesy light, and handle trim, remove the panel screws and clips, and lift the door panel away before peeling back the water shield.
Remove the old exterior handle
Disconnect the lock rods from their clips and remove the access plug. Remove the handle mounting bolts, withdraw the handle, disconnect its latch rod, and remove the lock cylinder fastener and cylinder.
Transfer the lock cylinder and fit the handle
Install the lock cylinder in the replacement handle and secure its fastener. Reconnect the latch rod, position the handle in the door, tighten its mounting bolts, and reconnect the lock rods.
Reassemble and test the door
Restore the water shield and reconnect the switch and courtesy light. Align the panel and press in its clips, reinstall the screws and trim, reconnect the battery, and test the key and latch.
Check your vehicle’s repair manual for exact specifications and fit.