How To Replace Rear Brakes 00-05 Buick LeSabre
Difficulty: Intermediate · About 60 min · Buick Lesabre
Service the rear pads and rotors on this disc-brake setup, keeping the caliper supported and checking the brake pedal before moving the car.
Tools you will need
- Floor Jack
- Jack Stands
- 15mm Socket
- 12mm Socket
- Large C-Clamp
- Torque Wrench
Parts and supplies
- Rear brake pads
- Rear brake rotors, if worn
Steps
Raise the vehicle and remove the wheel
Loosen the lug nuts on the ground, lift the vehicle at approved points, and support it on jack stands. Remove the wheel and inspect the pads and rotor.
Remove the caliper and bracket
Remove the caliper fasteners and lift the caliper away without stretching its hose. Support it securely, then remove the bracket fasteners and rotor if replacement is needed.
Install the serviceable brake parts
Seat the rotor on the hub and reinstall the bracket using vehicle-specific torque values. Fit the new pads, then compress the piston slowly with an appropriate clamp before refitting the caliper.
Refit the wheel and check pedal feel
Install the wheel and tighten the lug nuts in a crossing pattern to specification. Before driving, pump the brake pedal until firm and verify braking at walking speed in a clear area.
Check your vehicle’s repair manual for exact specifications and fit.