How to Replace License Plate Bracket 02-06 GMC Envoy XL
Difficulty: Beginner · About 30 min · Gmc Envoy
Replace the rear license plate bracket on a 2002–2006 GMC Envoy XL by removing its existing fasteners and fitting a secure replacement.
Tools you will need
- Flat blade screwdriver
- Drill
- 1/4 inch drill bit
Parts and supplies
- License plate bracket
- Bracket fasteners
Steps
- Remove the old bracket
Remove the bracket fasteners, prying out plastic retainers with a flat screwdriver where fitted. Pull the bracket away and inspect the mounting surface for damage.
- Position the replacement
Align the new bracket with the existing mounting points. If new holes are required, confirm the location and clearance behind the panel before drilling.
- Secure the bracket
Install suitable fasteners through the bracket and into the mounting points. Tighten them securely without distorting the bracket or surrounding body panel.
- Check the installation
Confirm the bracket is stable and level, then mount the license plate using appropriate hardware. Ensure no sharp edges or loose fasteners remain.
Check your vehicle’s repair manual for exact specifications and fit.