How to Change Oil 10-16 Cadillac SRX
Difficulty: Beginner · About 35 min · Cadillac Srx
Change the engine oil and filter on a 2010–2016 Cadillac SRX using the specified oil grade and amount, and reset the service reminder after the level check.
Tools you will need
- 15 mm wrench
- Oil-filter wrench
- Drain pan
- Funnel
- Jack stands
Parts and supplies
- Engine oil meeting vehicle specification
- Replacement oil filter
- Drain-plug seal if required
Steps
Prepare and drain the oil
Park level, allow the engine to cool enough to work safely, and support the vehicle on rated stands at approved lift points. Place a drain pan below the sump, remove the drain plug, and let the old oil drain fully.
Reinstall the drain plug
Inspect the plug seal and replace it if worn. Start the plug by hand and tighten it to the vehicle specification, then wipe the pan clean so later leaks are visible.
Replace the oil filter
Use a filter wrench to loosen the filter and catch the remaining oil. Confirm the old gasket came off, lubricate the new filter seal with fresh oil, and install the filter by hand as directed by its manufacturer.
Refill and verify the level
Add the specified oil gradually through a funnel, using the owner’s manual for capacity and grade. Start the engine briefly, check for leaks, shut it off, wait for the oil to settle, and verify the dipstick level.
Reset the service reminder
Use the vehicle’s driver-information controls and owner’s manual procedure to reset the oil-life reminder only after completing the service. Recheck the oil level and ensure the drain plug and filter remain dry.
Check your vehicle’s repair manual for exact specifications and fit.