How to Replace Rear Shocks 03-08 Honda Pilot
Difficulty: Intermediate · About 90 min · Honda Pilot
Replace rear shock absorbers on a 2003–2008 Honda Pilot. Support the vehicle and control arm securely, align the mounts before tightening, and use the specified torque for the exact model and year.
Tools you will need
- Floor jack
- Jack stands
- 17mm socket
- 19mm socket
- Ratchet
- Torque wrench
Parts and supplies
- Rear shock absorbers
Steps
Raise and support the vehicle
Loosen the rear wheel nuts while the vehicle is on the ground. Raise it at approved lift points, support it on jack stands, and remove the wheel.
Remove the old shock
Support the suspension arm, loosen the upper and lower shock fasteners, and remove the lower connection first. Ease the shock from its mounts without disturbing the spring.
Install the replacement shock
Position the new shock and start both ends by hand. Raise the arm slightly to align the mounts, then tighten the upper and lower fasteners to vehicle specification.
Reinstall the wheel and inspect
Refit the wheel, lower the vehicle, and tighten lug nuts in a star pattern to specification. Check that both shock mounts are seated and listen for abnormal noises on a cautious drive.
Check your vehicle’s repair manual for exact specifications and fit.