How to Replace Power Window Regulator Motor Front Driver Side 01-07 Toyota Highlander
Difficulty: Intermediate · About 130 min · Toyota Highlander
Replace the driver-side front window motor on a 2001–2007 Toyota Highlander, removing the glass and regulator for access, then reconnecting the handle cables and switch.
Tools you will need
- Razor Blade / Gasket Scraper
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- White Grease
- 10mm Socket
- Ratchet
- Trim Tool Set
- T25 Torx Driver
Parts and supplies
- Front driver-side window regulator motor
Steps
Remove the driver door panel
Pry off the master switch, door pull, sail panel, and handle trim. Remove the panel fasteners, release the clips, lift the panel away, and disconnect the courtesy light and handle cables.
Remove the speaker and glass
Remove the speaker bolts, unplug its wiring, and set it aside. Remove the two glass fasteners and carefully lift the glass out through the top of the door.
Remove the regulator and motor
Unplug the window motor and remove the regulator fasteners. Remove the T25 motor screws and separate the motor from the regulator.
Install the new motor and regulator
Press the replacement motor onto the regulator and secure its screws. Hang the regulator on its mounting bolt, tighten the remaining fasteners, then lower the glass into place and secure it.
Reassemble and test the door
Reinstall the speaker and reconnect its wiring, then restore the water barrier. Reconnect the handle cables and courtesy light, refit the door panel and switch, and test the window through its full travel.
Check your vehicle’s repair manual for exact specifications and fit.