How to Remove Intake Tube 98-12 Ford Crown Victoria
Difficulty: Beginner · About 20 min · Ford Crown Victoria
Remove and refit the intake tube on a 1998–2012 Ford Crown Victoria to inspect or replace the duct, reconnecting the breather hoses and mass-airflow sensor correctly.
Tools you will need
- 1/4 Inch Ratchet
- Socket Extensions
- Flat Blade Screwdriver
Steps
Disconnect the intake components
Switch off the ignition and let the engine cool. Remove the engine-cover fastener with a 1/4-inch ratchet and lift the cover away. Unplug the mass-airflow sensor connector, release the air-box clips, and lift the air-box lid enough to access the duct.
Remove the intake tube
Disconnect both breather hoses from the intake duct. Loosen the intake boot clamp and carefully separate the tube from the throttle body and air box, keeping dirt out of the open intake ports.
Reinstall the tube and hoses
Seat the intake tube fully at both ends and tighten its clamp so the duct seals without being crushed. Reconnect both breather hoses and close the air-box lid, confirming its clips engage evenly.
Reconnect the sensor and inspect
Plug the mass-airflow sensor connector back in until its lock clicks, then reinstall the engine cover. Check that every hose and clamp is secure and that no tools or loose material remain near the intake before starting the engine.
Check your vehicle’s repair manual for exact specifications and fit.