How to Replace Window Regulator 04-15 Nissan Titan
Difficulty: Intermediate · About 75 min · Nissan Titan
Replace the window regulator on a 2004–2015 Nissan Titan, securing the glass before removing the motor and regulator, then reinstalling the door panel and checking alignment.
Tools you will need
- Flat Blade Screwdriver
- 7mm Socket
- Painter's Tape
- 10mm Socket
- Ratchet
Parts and supplies
- Power window regulator
Steps
Remove the door panel
Pry off the handle and pull trim, remove their 10 mm bolts, and unplug the switch pack. Release the panel clips, lift the panel off the sill, disconnect the courtesy light and handle cables, then peel back the water shield.
Secure the glass and remove the regulator
Remove the glass clamp bolts, raise the window by hand, and tape it securely to the door frame. Disconnect the door wiring, loosen the regulator fasteners, remove the motor bolts, and guide the assembly out.
Transfer the motor and install the regulator
Remove the motor from the old regulator and mount it to the replacement. Feed the new regulator into the door, start its fasteners, reconnect the wiring, remove the tape, and lower the glass onto its clamps.
Reassemble and test
Tighten the glass clamp bolts and test the window through its travel. Restore the water shield, reconnect the handle cables and courtesy light, and refit the panel, switch, screws, and trim.
Check your vehicle’s repair manual for exact specifications and fit.