How to Replace Front Brakes 07-10 Hyundai Elantra
Difficulty: Intermediate · About 90 min · Hyundai Elantra
Replace the front pads and rotors on a 2007–2010 Hyundai Elantra, clean and lubricate the slide hardware, and confirm a firm pedal before road testing.
Tools you will need
- Socket Extensions
- Torque Wrench
- 14mm Socket
- Rust Penetrant
- Pry Bar
- 17mm Socket
- Jack Stands
- Brake Parts Cleaner
- Pocket Screwdriver
- Pliers
- 21mm Socket
- Blowtorch
- Anti-Seize Grease
- Brake Grease
- 10mm Socket
- Ratchet
- Wire Brush
- Floor Jack
- 1/2 Inch Breaker Bar
Parts and supplies
- Front brake pads
- Front brake rotors
Steps
Raise the vehicle and remove a wheel
Loosen the lug nuts, raise the front, and support the vehicle on stands. Remove a wheel and set the hardware aside where it will stay clean.
Remove the caliper and rotor
Remove the caliper slide bolts and support the caliper without stretching its hose. Remove the bracket fasteners, bracket, pads, and rotor from the hub.
Clean the caliper slides and clips
Remove the pad clips and slide pins. Clean the bracket channels, clips, pins, and boots, then apply brake lubricant sparingly to the sliding surfaces and reinstall the hardware.
Install the rotor and pads
Clean the hub face and rotor, then install the rotor and bracket. Fit the pads, retract the caliper piston slowly, and reinstall the caliper with all fasteners tightened to specification.
Refit the wheel and test
Reinstall the wheel and torque its lug nuts to specification in a star pattern. Pump the brake pedal gently until firm, then test at low speed before normal driving.
Check your vehicle’s repair manual for exact specifications and fit.