How to Replace Install Rear Exterior Door Handle 14 Toyota Tundra
Difficulty: Beginner · About 65 min · Toyota Tundra
Replace the rear exterior door handle on a 2014 Toyota Tundra by removing the trim and latch rod, securing the new handle through the door skin, and testing the latch before reassembly.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- 10mm Socket
- Ratchet
- Trim Tool Set
Parts and supplies
- Rear exterior door handle
Steps
Remove the rear door panel
Pry up the window switch and unplug it, then remove the trim and screws from the panel and pull handle. Release the clips, lift the panel away, and disconnect the handle cables.
Disconnect and remove the handle
Pull the access plugs from the door and release the colored latch rod clip. Withdraw the rod from the handle, remove the two 10 mm nuts while supporting the handle, and pull the handle outward.
Install the replacement handle
Position the new handle using its locating studs and install the two retaining nuts. Reconnect the latch rod and retaining clip, then press the access plugs back into the door.
Reinstall the door panel
Reconnect the handle cables and switch wiring, align the panel and press its clips into place. Reinstall the pull screws and trim pieces, then operate the handle and lock to confirm proper latching.
Check your vehicle’s repair manual for exact specifications and fit.