How to Replace Power Steering Pump 06-11 Toyota Camry

Difficulty: Advanced · About 150 min · Toyota Camry

Replace the power-steering pump on a 2006–2011 Toyota Camry, contain the fluid, transfer compatible fittings and switch, and bleed the system after refilling.

Steps

1. Drain the reservoir

   Place a drain pan below the reservoir, loosen the hose clamps, and remove the reservoir fasteners. Disconnect the hoses and let the fluid drain into the pan.

2. Raise the vehicle and remove the wheel

   Loosen the wheel nuts, raise and support the front securely, then remove the wheel to reach the pump belt and lower mounting area.

3. Release the belt and remove the pump

   Rotate the tensioner to release belt tension and slip the belt off the pump pulley. Disconnect the return hose, electrical plug, and pressure fitting, then remove the pump fasteners.

4. Transfer fittings to the replacement pump

   Move the pressure switch and compatible hard line to the new pump, using clean seals and undamaged fittings. Confirm all shipping plugs are removed before installation.

5. Install the pump and reconnect lines

   Position the replacement pump in its bracket and tighten the mounting fasteners to specification. Reconnect the pressure line with new sealing washers, the return hose, and electrical plug.

6. Refit the belt and reservoir

   Route the belt according to the diagram and release the tensioner slowly. Reinstall the reservoir and hoses, fill to the correct level, and reinstall the wheel.

7. Bleed and inspect the system

   Start the engine and turn the steering slowly from side to side without holding against the stops. Check fluid level and inspect all fittings for leaks, topping up with the specified fluid.

Check your vehicle’s repair manual for exact specifications and fit.