How to Replace Rear Window Regulator 00-04 Nissan Frontier
Difficulty: Intermediate · About 75 min · Nissan Frontier
Replace the rear window regulator on a 2000–2004 Nissan Frontier by taping the glass in place, changing the regulator and motor assembly, and checking full window travel before closing the door.
Tools you will need
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- Painter's Tape
- 10mm Socket
- Ratchet
Parts and supplies
- Rear power window regulator
Steps
Remove the door panel
Remove the lower panel screws and door pull, then release the handle bezel and panel clips. Lift the panel away, disconnect the switch wiring, and peel back the vapor barrier.
Secure the glass and remove the regulator
Lower the glass enough to access its two mounting bolts, loosen them, then raise the glass by hand and secure it with painter's tape. Disconnect the motor and door wiring, remove the regulator and motor fasteners, and guide the assembly out.
Install the new regulator
Feed the replacement into the door and loosely hang it on an upper fastener. Align the motor tabs, install the remaining regulator and motor bolts, remove the tape, and lower the glass onto its mounts.
Reassemble and test the window
Reconnect the motor and switch wiring, tighten the glass mounting bolts, and cycle the window to check alignment. Restore the vapor barrier and door panel, then reinstall its screws, pull, and bezel.
Check your vehicle’s repair manual for exact specifications and fit.