How to Replace Front Sway Bar Links 07-10 Hyundai Elantra
Difficulty: Intermediate · About 90 min · Hyundai Elantra
Replace the front stabilizer links on a 2007–2010 Hyundai Elantra. Support the vehicle evenly, prevent the joint studs from spinning, and torque link and wheel hardware to the correct vehicle specification.
Tools you will need
- Floor jack
- Jack stands
- 21mm socket
- 17mm socket
- 18mm socket
- Locking pliers
- Torque wrench
Parts and supplies
- Front stabilizer links
Steps
Raise and support the front
Loosen wheel nuts on the ground, raise the front at approved points, and support both sides securely on jack stands. Remove the wheels for access to the links.
Remove the old links
Hold each stud from turning and remove the upper and lower nuts. Work both sides so the stabilizer bar can move freely, then remove the worn links.
Install the replacement links
Position each link in the original orientation and start its nuts by hand. Hold the studs steady, tighten all link hardware to vehicle specification, and confirm the bar is not preloaded unevenly.
Reinstall the wheels and inspect
Refit the wheels and torque their nuts in a star pattern to specification. Lower the car and check for link contact, loose hardware, or new suspension noise.
Check your vehicle’s repair manual for exact specifications and fit.