How to Replace Front Brakes 05-10 Hyundai Accent

Difficulty: Advanced · About 75 min · Hyundai Accent

Replace the front brake pads and rotors on a 2005–2010 Hyundai Accent by supporting the vehicle securely, cleaning the hub and slides, and confirming firm pedal operation.

Steps

1. Raise the vehicle and remove the wheel

   Park on level ground, chock the rear wheels, and loosen the lug nuts slightly. Raise the front using approved lift points and support it on jack stands, then remove the wheel and keep the hardware together.

2. Remove the caliper and pads

   Remove the caliper guide bolts and lift the caliper from the rotor. Support it so the brake hose is not stretched, then remove the old pads and pad slides. Compress the piston slowly with a clamp, checking the brake-fluid reservoir as the level rises.

3. Remove the bracket and rotor

   Remove the caliper-bracket bolts and lift the bracket away. Remove the rotor retaining screws and slide the rotor off. If it is seized, apply penetrant and use a rubber mallet carefully on the rotor hat, avoiding the wheel studs and hub.

4. Clean and install the new rotor

   Brush rust from the hub face and pad-contact surfaces. Clean the new rotor with brake cleaner or mineral spirits and wipe it dry. Install the rotor and caliper bracket, start the bolts by hand, and tighten them to the vehicle's specification.

5. Install the pads and caliper

   Clean and lubricate the pad slides and caliper guide points with brake-compatible grease. Fit the new pads, reinstall the caliper over the rotor, and tighten its guide bolts to the vehicle's specification. Confirm the pads sit squarely in their guides.

6. Reinstall the wheel and verify braking

   Mount the wheel and start the lug nuts by hand. Lower the vehicle and tighten the nuts in a star pattern to the vehicle's specification. Pump the brake pedal until firm, inspect the fluid level, and perform a gentle low-speed brake check in a clear area.

Check your vehicle’s repair manual for exact specifications and fit.