How to Replace Power Mirror Switch 05-10 Chrysler 300

Difficulty: Intermediate · About 40 min · Chrysler 300

Replace the power mirror switch on a 2005–2010 Chrysler 300 by removing the driver door panel and transferring the switch into its housing.

Steps

1. Remove the door panel

   Switch off the ignition and release the small trim covers around the handle and pull cup. Remove the exposed screws and perimeter fasteners, then carefully free the panel clips.

2. Disconnect the panel wiring

   Lift the panel away from the door and unplug the window-switch and courtesy-light connectors. Release the handle cable from its retainer and set the panel on a protected surface.

3. Replace the mirror switch

   Release the master-switch housing tabs and remove the mirror switch from the panel. Seat the replacement switch in the same orientation and confirm its retaining tab locks.

4. Reassemble the door

   Reconnect the courtesy lamp, window-switch harness, and latch cable. Align the panel over the lock and press each clip into place before reinstalling the screws and trim covers.

5. Test the controls

   Turn on the ignition and test mirror adjustment and all window switches. Confirm the door handle, courtesy light, and panel are secure before closing the door.

Check your vehicle’s repair manual for exact specifications and fit.