How to Replace Wiper Motor 09-19 Ford Fiesta
Difficulty: Intermediate · About 60 min · Ford Fiesta
Replace the windshield wiper motor on a Ford Fiesta while preserving blade positions and checking the arms park correctly after reassembly.
Tools you will need
- 15mm Wrench
- Trim Tool Set
- 8mm Socket
- 10mm Socket
- T30 Driver
Parts and supplies
- Wiper motor or transmission assembly
Steps
Mark and remove the wiper arms
Mark the parked position of each blade on the windshield with tape. Remove the arm caps and nuts, then rock the arms off their splines.
Remove the cowl panel
Release the cowl clips and windshield seal, then lift the panel away. Remove the wiper transmission fasteners and disconnect its washer hose and wiring.
Replace the motor
Separate the motor from the linkage while holding the crank arm steady. Install the replacement motor, reconnect the linkage, and secure the assembly in the vehicle.
Reassemble and set blade position
Reinstall the cowl and seals, then mount both arms to the windshield tape marks. Tighten the arm fasteners to specification and test low and high speed operation and parking.
Check your vehicle’s repair manual for exact specifications and fit.