How to Replace Headlight Bulbs 10-14 Subaru Outback

Difficulty: Beginner · About 25 min · Subaru Outback

Replace the low beam, high beam, driving light, turn signal, and marker bulbs on a 2010-2014 Subaru Outback.

Steps

1. Replace the low beam bulb

   Twist the outer cover counterclockwise to remove it, pull off the electrical connector, push the spring retainer's arms down and in to unlock it, lift it free, pull out the H7 bulb, insert the new one using its tab for alignment, close and lock the retainer, reconnect the connector, then twist the cover back on clockwise.

2. Replace the high beam bulb

   Twist the inner large bulb counterclockwise to remove it, disconnect its connector, insert the new 9005 bulb using its tabs for alignment, twist it clockwise to lock it in, then reconnect the connector.

3. Replace the driving light bulb

   Twist the small socket next to the high beam counterclockwise to remove it, pull out the 194 bulb, insert the new one, reinsert the socket into the assembly, then twist it clockwise to lock it in.

4. Replace the turn signal bulb

   Twist the socket at the top outer corner counterclockwise to remove it, pull out the WY21W bulb, insert the new one, reinsert the socket, then twist it clockwise to lock it in.

5. Replace the marker light bulb

   Twist the socket next to the low beam counterclockwise to remove it, pull out the 194 bulb, insert the new one, reinsert the socket, then twist it clockwise to lock it in.

Check your vehicle’s repair manual for exact specifications and fit.