How to Replace Parking Brakes 05-10 Chrysler 300
Difficulty: Advanced · About 150 min · Chrysler 300
Replace the rear parking brake shoes and hardware on a 2005–2010 Chrysler 300 after removing the brake rotor and hub assembly, then adjust the shoes and verify the parking brake holds evenly.
Tools you will need
- 13mm Socket
- Hammer
- Torque Wrench
- 15mm Socket
- Pry Bar
- E12 Inverted Torx Socket
- 18mm Socket
- Bungee Cord
- 22mm Wrench
- 1/2 Inch Breaker Bar
Parts and supplies
- Rear parking brake shoes
- Parking brake hardware kit
- Axle nut
Steps
Raise the vehicle and remove the wheel
Release the parking brake, chock the front wheels, and loosen the rear wheel nuts. Raise the rear securely on stands and remove the wheel.
Remove the caliper and rotor
Remove the caliper fasteners and support the caliper without straining its hose. Remove the pads and bracket, then release the rotor from the hub and inspect its parking-brake drum surface.
Remove the axle nut and hub
Use the correct hub-holding method and socket to remove the axle nut. Keep the axle threads protected, then remove the hub mounting bolts from the back of the knuckle and withdraw the hub assembly.
Remove the old parking brake shoes
Note the shoe and spring arrangement before disassembly. Remove the return springs and adjuster with suitable brake-spring tools, then release the retainers and lift the shoes off the backing plate.
Install the new shoes and hardware
Clean the backing plate contact pads and inspect the cable and adjuster. Fit the new shoes, adjuster, springs, and retainers in the original orientation, confirming each spring is fully seated and the shoes move freely.
Reinstall the hub and service brakes
Position the hub assembly and tighten its fasteners to the vehicle specification. Refit the rotor, caliper bracket, pads, and caliper; keep grease off all friction surfaces and tighten brake fasteners to specification.
Adjust and test the parking brake
Install and torque the axle nut and wheel fasteners to the manufacturer's values. Adjust the parking brake shoes to the service specification, pump the brake pedal until firm, and verify the parking brake holds the vehicle before road use.
Check your vehicle’s repair manual for exact specifications and fit.