How to Replace Rear Wiper Arm 08-12 Ford Escape

Difficulty: Beginner · About 20 min · Ford Escape

Replace the rear wiper arm on a 2008–2012 Ford Escape, clean the motor spindle threads, and position the arm so it clears the glass correctly.

Steps

1. Remove the old wiper arm

   Lift the small cover at the arm base and remove the retaining nut with a 13mm socket. Hold the arm and pull it from the motor spindle; use a suitable puller if corrosion makes it stick.

2. Prepare the replacement

   Clean debris from the spindle threads with a wire brush and inspect them for damage. Attach the new blade to the replacement arm if needed, confirming its latch is fully engaged.

3. Position and secure the arm

   Place the arm over the spindle in the parked position, using the glass marks or prior sweep path as a guide. Start the retaining nut by hand and tighten it securely, then close the cover.

4. Test the sweep

   Run the rear wiper briefly and confirm it parks correctly and sweeps the intended glass area. Adjust the arm position if it contacts trim or leaves the normal sweep path.

Check your vehicle’s repair manual for exact specifications and fit.