How to Replace Rear Window Regulator Motor 07-11 Toyota Camry
Difficulty: Intermediate · About 100 min · Toyota Camry
Replace the rear window regulator motor on a 2007–2011 Toyota Camry, removing the glass channel and regulator to transfer the motor before restoring the door wiring and trim.
Tools you will need
- Razor Blade / Gasket Scraper
- Gloves
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- 10mm Socket
- Ratchet
- T25 Torx Driver
Parts and supplies
- Rear power window regulator motor
Steps
Remove the rear door panel
Pry off the handle and pull trim, remove their Phillips screws, and release the panel clips. Lift the panel away, disconnect the switch harness, and transfer any clips left in the door back to the panel.
Remove the window channel and regulator
Disconnect the motor lead and pull back the weather barrier. Remove the window run channel and its fastener, raise the glass by hand, then remove the regulator bolts and withdraw the assembly.
Transfer the regulator motor
Remove the three T25 screws securing the motor and separate it from the regulator. Fit the replacement motor onto the bracket and install its retaining screws.
Reinstall the regulator and channel
Feed the regulator into the door and loosely hang it on a mounting bolt. Lower the glass onto the regulator, refit its channel and weather seal, and reconnect the motor lead.
Reconnect the handle and door trim
Reconnect the latch and lock cables to their proper positions and refit the inner handle. Connect the switch harness, align the panel clips, reinstall its screws and trim, and test the window and door lock.
Check your vehicle’s repair manual for exact specifications and fit.