How to Perform Oil Change 11-17 Toyota Camry
Difficulty: Intermediate · About 50 min · Toyota Camry
Change the engine oil and filter on an 2011–2017 Toyota Camry, replacing the filter-housing seals and filling with the exact oil specification for the engine.
Tools you will need
- 14 mm socket and ratchet
- Oil-filter housing tool
- Torque wrench
- Drain pan and funnel
- Rated jack stands
Parts and supplies
- Engine oil matching the owner’s manual
- Oil filter element and housing seals
Steps
Prepare the vehicle
Park on level ground, switch off the engine, and allow the oil to cool enough for safe handling. Raise and support the vehicle at approved lift points, place a drain pan below the sump, and remove the oil filler cap.
Drain the oil
Remove the drain plug and let the used oil drain completely. Replace the plug seal if needed, start the plug by hand, and tighten it to the vehicle specification.
Remove and service the filter housing
Use the correct filter-housing tool to loosen the cap and remove the old filter. Replace the housing O-ring and drain-plug seals with the correct parts, then clean the housing and mating surface.
Install the new filter
Seat the new filter and lubricate the new O-ring lightly with fresh oil. Refit the housing and tighten it to the vehicle specification with a torque wrench.
Refill and check
Add the specified oil gradually through a funnel, using the owner’s manual for capacity. Start the engine briefly, check for leaks, shut it off, wait for oil to settle, and verify the dipstick level.
Check your vehicle’s repair manual for exact specifications and fit.