How to Replace Rear Door Lock Actuator 07-13 Toyota Camry
Difficulty: Intermediate · About 75 min · Toyota Camry
Replace the rear door lock actuator on a 2007–2013 Toyota Camry by removing the door trim and water shield, transferring the latch cables, and checking the power lock.
Tools you will need
- Razor Blade / Gasket Scraper
- Gloves
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- T30 Driver
- Trim Tool Set
Parts and supplies
- Rear door lock actuator
Steps
Remove the rear door panel
Pry off the handle and pull trim, remove their screws, and release the door panel clips. Lift the panel away, disconnect the switch, and transfer any clips left in the door back to the panel.
Remove the old actuator
Peel back the water shield and slide its cables clear. Disconnect the actuator connector, release its rod clip and cable retainers, remove the T30 fasteners, and lift the actuator out.
Install the replacement actuator
Transfer the latch cables to the new actuator and seat their retainers fully. Position the actuator in the door, tighten its fasteners, reconnect the electrical plug, and press the water shield back in place.
Reconnect the handle and test the lock
Reconnect the latch cables to the interior handle and secure the handle in the panel. Reconnect the switch, align and clip the panel into place, reinstall its screws and trim, and test the power lock.
Check your vehicle’s repair manual for exact specifications and fit.