How to Replace Mirror 01-03 Chrysler Voyager
Difficulty: Beginner · About 25 min · Chrysler Voyager
Replace a side mirror on a 2001–2003 Chrysler Voyager by removing the exterior bezel and Torx fasteners, reconnecting power wiring if equipped, and checking operation.
Tools you will need
- T27 Torx driver
- Flat blade screwdriver
Parts and supplies
- Side view mirror
Steps
- Remove the mirror bezel
From outside the door, carefully release the mirror's trim bezel with a protected flat blade tool. Avoid scratching the paint or breaking the retaining tabs.
- Remove the old mirror
Remove the two visible T27 screws and open the door to reach the third fastener. Support the mirror as the last screw comes out, and unplug the harness if the mirror has power or heat.
- Install the replacement mirror
Route and reconnect the harness where equipped, then hold the mirror against the door. Start all three T27 screws by hand and tighten them securely before pressing the bezel back into place.
- Verify mirror operation
Adjust the mirror from inside the vehicle and confirm the heater works if fitted. Check that the bezel is seated evenly and the mirror remains stable.
Check your vehicle’s repair manual for exact specifications and fit.