How to Replace Power Window Motor 01-07 Toyota Sequoia

Difficulty: Intermediate · About 75 min · Toyota Sequoia

Replace the power window motor on a 2001–07 Toyota Sequoia, keeping the glass supported and the regulator balance spring controlled during transfer.

Steps

1. Disconnect the battery

   Switch the ignition off and disconnect the negative battery cable. Keep the terminal isolated while the door wiring is exposed.

2. Remove the door panel and speaker

   Release the trim covers and screws, unplug the switches and courtesy light, then lift the panel off its clips. Peel back the water shield and remove the speaker for access.

3. Support the window and remove the regulator

   Disconnect the motor lead and remove the glass and regulator fasteners. Raise the glass fully, secure it with tape, then guide the regulator out through the door.

4. Separate the motor from the regulator

   Control the regulator spring tension before removing the motor screws. Keep the spring and regulator arm secured as you separate the old motor from the assembly.

5. Install the replacement motor

   Position the new motor on the regulator and start its fasteners by hand. Tighten them evenly, then carefully reconnect the balance spring while controlling its tension.

6. Reinstall and test the regulator

   Return the regulator to the door and secure its mounting bolts. Reconnect the motor and battery temporarily, lower the regulator to align the glass, remove the tape, and fasten the glass clamps.

7. Reassemble the door

   Disconnect power as needed and restore the water shield and speaker. Reconnect the door wiring, refit the panel and trim, then reconnect the battery and verify smooth window travel.

Check your vehicle’s repair manual for exact specifications and fit.