How to Replace Front Drivers Exterior Door Handle 05-10 Chrysler 300

Difficulty: Intermediate · About 70 min · Chrysler 300

Replace the front driver exterior door handle on a 2005–2010 Chrysler 300 and reconnect its lock and latch rods.

Steps

1. Remove the door panel

   Release the handle trim and panel clips, remove the pull and lower screws, then lift the panel away. Disconnect the latch cable, switch wiring, and courtesy lamp before setting the panel aside.

2. Access the exterior handle

   Unplug the door control module and release its retainers. Carefully peel the water shield back, unclip the lock and latch rods, then remove the handle fasteners and lock cylinder to free the handle.

3. Install the replacement handle

   Position the new handle from the front edge and seat it in the door. Reinstall its fasteners and lock cylinder, reconnect both rods and their clips, then reconnect the module and wiring retainers.

4. Restore the water shield and panel

   Seal the water shield back against the door, reconnect the courtesy lamp, switches, and latch cable, then hang and clip the panel in place. Reinstall the screws and trim, and test the handle and lock with the door open.

Check your vehicle’s repair manual for exact specifications and fit.