How to Replace Wheel Bearing & Hub 10-16 Cadillac SRX
Difficulty: Intermediate · About 90 min · Cadillac Srx
Replace the front wheel hub on a 2010–16 Cadillac SRX, supporting the caliper and protecting the speed sensor while transferring the backing plate.
Tools you will need
- Floor jack
- Jack stands
- 22 mm socket
- 18 mm socket
- T30 driver
- 10 mm socket
- Wire brush
- Bungee cord
- Torque wrench
Parts and supplies
- Front wheel hub assembly
- Axle nut, if required
Steps
Raise and remove the wheel
Loosen the lug nuts on the ground, raise and support the vehicle securely, then remove the wheel.
Remove caliper and rotor
Remove the caliper bracket fasteners and hang the caliper securely from the suspension. Remove the rotor retaining screw and lift the rotor off the hub.
Remove the hub assembly
Loosen the axle nut using the correct holding tool, then disconnect the wheel-speed sensor. Remove the hub bolts and tap the hub free without damaging the axle or backing shield.
Prepare and install the new hub
Clean the backing plate and knuckle mating surfaces. Position the plate and replacement hub, start its bolts by hand, then tighten evenly to vehicle specification.
Reconnect the axle and sensor
Reinstall the axle nut and speed sensor fastener, routing the wire away from moving parts. Tighten the axle nut to the vehicle's specification.
Reinstall rotor and caliper
Clean corrosion from the rotor contact surface and install the rotor. Refit the caliper bracket and caliper, tightening their bolts to specification.
Reinstall the wheel and test
Mount the wheel and torque lug nuts to specification. Check for ABS warnings, bearing noise, and brake drag during a cautious test drive.
Check your vehicle’s repair manual for exact specifications and fit.