How to Replace Windshield Washer Reservoir 98-02 Honda Accord
Difficulty: Intermediate · About 60 min · Honda Accord
Replace the windshield washer reservoir on a 1998–2002 Honda Accord by removing the bumper cover, transferring the pump and grommet, then refilling and testing the system.
Tools you will need
- 8mm socket
- 10mm socket and extensions
- Ratchet
- Drain pan
Parts and supplies
- Windshield washer reservoir
- Washer pump grommet as needed
Steps
Remove the bumper cover
Remove the fasteners inside both inner fenders and release the upper and lower bumper clips. Pull the cover away carefully to expose the washer reservoir.
Remove the old reservoir
Place a drain pan below the washer system and remove the pump from the reservoir. Transfer the pump grommet and cap, then remove the three 10mm reservoir bolts and lower the tank out.
Install the replacement reservoir
Position the new reservoir and reinstall its three bolts. Seat the grommet and pump fully, then reconnect the washer hose to its retainer.
Refill and reinstall the bumper
Fill the reservoir with suitable washer fluid and reinstall its cap. Align the bumper cover, fit the top and bottom clips, and reinstall the inner fender bolts.
Test for leaks and spray
Operate the windshield washers and confirm fluid reaches the glass. Inspect the pump and hose connection for leaks before driving.
Check your vehicle’s repair manual for exact specifications and fit.