How to Replace Interior Door Handle 93-03 Ford Ranger
Difficulty: Intermediate · About 90 min · Ford Ranger
Replace the interior door handle on a 1993–2003 Ford Ranger by drilling out the original rivet, reconnecting the latch rod, and securing the new handle with the specified replacement fastener.
Tools you will need
- Coarse Threaded Bolts (to replace rivets)
- Flat Blade Screwdriver
- T20 Driver
- Phillips Head Screwdriver
- 1/4 Inch Drill Bit
- Drill
Parts and supplies
- Interior door handle
- Coarse threaded replacement bolt
Steps
- Remove the door panel
Release the window-crank cover and remove the crank fastener. Take out the screws in the pull handle and behind the bezel, then lift the door panel up and away from the door.
- Free the old handle and latch rod
Drill through the center of the handle rivet with a 1/4-inch bit and remove the rivet head. Pull the handle from the door, peel back the water shield carefully, and release the latch rod from its clip.
- Install the new handle
Reconnect the latch rod and refit its retaining clip. Position the new handle in the door opening and secure it with the specified coarse-thread replacement bolt in place of the removed rivet.
- Reinstall the water shield and door panel
Press the water shield back into place so it seals around the opening. Refit the door panel, bezel, pull-handle screws, and window crank, then operate the handle from inside to confirm the latch releases and returns smoothly.
Check your vehicle’s repair manual for exact specifications and fit.