How to Replace Rear Engine Mount 01-05 Honda Civic
Difficulty: Advanced · About 70 min · Honda Civic
Replace the rear engine mount on a 2001–2005 Honda Civic, supporting the engine and exhaust before removing the mount bracket and tightening the replacement at the specified positions.
Tools you will need
- Socket Extensions
- Torque Wrench
- 14mm Socket
- 17mm Wrench
- Rust Penetrant
- Channel-Lock Pliers
- 17mm Socket
- Jack Stands
- Ratchet
- Floor Jack
- Block of Wood
Parts and supplies
- Rear engine mount
- Wheel lug nuts
Steps
Lift the vehicle and remove the wheel
Loosen the wheel lug nuts, raise the vehicle, and support it securely on jack stands. Remove the wheel to gain access to the rear engine mount fasteners.
Support the engine and move the exhaust
Place a floor jack with a broad wood block under a safe engine support point and raise it only enough to carry the load. Release the exhaust hangers carefully so the exhaust can move without straining its joints.
Remove the old mount
Remove the mount fasteners from the subframe and rear bracket. Turn the front wheels for clearance as needed, then lower the old mount and bracket out of the engine bay.
Prepare and install the new mount
Transfer the bracket to the replacement mount and leave its center fastener loose enough for alignment. Position the mount, hand-start all bracket bolts, and tighten them to the vehicle's specifications.
Restore the exhaust and wheel
Tighten the mount center fastener, lower the support jack slowly, and reconnect the exhaust hangers. Reinstall the wheel and torque its lug nuts to specification before checking for vibration or contact.
Check your vehicle’s repair manual for exact specifications and fit.