How To Replace Front Door Panel Trim 94-97 Honda Accord
Difficulty: Beginner · About 35 min · Honda Accord
Remove and reinstall the front door trim panel on a 1994–1997 Honda Accord while disconnecting the switches, courtesy lamp, speaker, and latch linkage carefully.
Tools you will need
- Phillips screwdriver
- Flat blade screwdriver
- Trim panel tool
- Cloth
Steps
- Remove the door screws and latch trim
Remove the Phillips screws from the door pull and latch area. Ease the latch trim outward, then unhook its lock linkage and disconnect any attached wiring without bending the rod.
- Disconnect switch and lamp panels
Use a protected trim tool to release the small corner trim, courtesy light cover, and window switch panel. Unplug the switch connector and set the panel aside where its wiring will not be pulled.
- Release and lift the door panel
Work around the door panel edge with a cloth-covered trim tool to release the clips. Lift the panel away and disconnect the courtesy lamp and speaker wiring before setting it down.
- Reconnect and refit the panel
Reconnect the speaker and courtesy light, then align the panel's upper edge and press its clips into their openings. Reattach the switch wiring and refit the switch, corner, and lamp trim pieces.
- Reinstall latch trim and screws
Reconnect the lock rod to the door latch and confirm its retaining clip is seated. Position the latch trim and install both Phillips screws, then test the handle, lock, window switch, and courtesy light.
Check your vehicle’s repair manual for exact specifications and fit.