How to Change Spare Tire 06-11 Toyota Camry

Difficulty: Beginner · About 30 min · Toyota Camry

Replace a flat tire on a 2006–2011 Toyota Camry using its designated jack point and temporary spare, then arrange a prompt lug-nut torque check.

Steps

1. Prepare the car

   Park on solid, level ground away from traffic, switch on hazard lights, set the parking brake, and select Park or a gear. Chock a wheel and retrieve the jack and spare from the trunk.

2. Loosen the lug nuts

   While the tire is still on the ground, loosen each nut slightly in a crossing pattern. Keep the wrench fully seated and leave the nuts installed until the car is raised.

3. Raise the vehicle and remove the wheel

   Place the jack at the vehicle’s marked jacking point and raise the car until the tire is clear. Remove the nuts, lift off the wheel, and keep yourself clear of the underside.

4. Install the spare

   Set the spare onto the hub and thread every lug nut by hand. Tighten lightly in a star pattern, lower the jack until the tire touches the ground, and snug the nuts again in sequence.

5. Finish and drive cautiously

   Lower the vehicle fully and tighten the nuts to the vehicle specification with a torque wrench as soon as possible. Store the flat and jack, then observe all temporary-spare speed and distance limits.

Check your vehicle’s repair manual for exact specifications and fit.