How to Replace Blower Motor Resistor 96-07 Ford Taurus
Difficulty: Beginner · About 25 min · Ford Taurus
Replace the HVAC fan speed resistor on a 1996–2007 Ford Taurus by lowering the glove box and under-dash trim, then reconnecting and testing the resistor.
Tools you will need
- 8mm socket and ratchet
Parts and supplies
- Blower motor resistor
Steps
- Remove lower trim and lower glove box
Pull the lower panel near its retaining pins to release it. Open the glove box and move its side tabs inward so it can swing down and expose the resistor area.
- Disconnect and remove the resistor
Unplug the resistor connector by releasing its lock. Remove the retaining bolts from below and withdraw the resistor from the HVAC case.
- Install the new resistor
Place the replacement resistor into its opening and align the fasteners. Reinstall the bolts securely, reconnect the electrical plug, and make sure the harness is routed clear of moving parts.
- Reassemble and test fan speeds
Raise the glove box and return its side tabs to their normal position. Press the lower trim panel back into its retainers, then test the blower at every speed.
Check your vehicle’s repair manual for exact specifications and fit.