How To Replace Rear Exterior Door Handle 07-13 GMC Yukon Denali
Difficulty: Intermediate · About 4 min · Gmc Yukon Denali
Replace the rear exterior door handle on a 2007–2013 GMC Yukon Denali by removing the inner trim and water shield, reconnecting the latch rod, and testing the lock and handle.
Tools you will need
- 10mm Wrench
- 10mm Socket
- Flat Blade Screwdriver
- Door Panel Removal Tool
- Putty Knife
Parts and supplies
- Compatible rear exterior door handle
Steps
Disconnect the battery
Switch the ignition off and disconnect the negative battery cable before unplugging door switches. Isolate the terminal from the battery post while working.
Remove the door panel
Pry off the handle and pull trim, remove the panel fasteners, and unplug the window switches. Release the panel clips, disconnect latch cables, and peel back the water shield carefully.
Remove the exterior handle
Release the latch rod clip and remove the access grommet. Unbolt the handle, slide it out of its guide, and transfer the rod to the replacement in the same orientation.
Install and connect the handle
Seat the replacement handle and slide it into its locked position. Tighten its fasteners, reconnect the rod clip, and reinstall the access grommet.
Reassemble and test
Restore the water shield, reconnect the latch cables and window switches, and refit the door panel and trim. Reconnect the battery, then check the handle, lock, and window operation.
Check your vehicle’s repair manual for exact specifications and fit.