How to Replace Rear Shocks 00-06 Toyota Tundra

Difficulty: Beginner · About 35 min · Toyota Tundra

Replace the rear shock absorbers on a Toyota Tundra, aligning the lower mounts with controlled axle support and tightening each end to specification.

Steps

1. Remove the old shock

   Park on level ground and chock the front wheels. Remove the upper retaining nut, then counterhold the lower nut while removing it and withdraw the shock.

2. Prepare and position the replacement

   Cycle the replacement shock by hand if its maker requires it. Transfer the bushings and washers in the correct order, then position the shock in the upper mount.

3. Align and secure the lower mount

   Raise the axle slightly with a floor jack until the lower shock eye aligns with its bracket. Install the lower hardware and tighten both ends to the vehicle specification.

4. Repeat and inspect

   Replace the opposite shock using the same method. Lower the vehicle and check that both upper and lower mounts are secure and the shocks are free of contact with nearby parts.

Check your vehicle’s repair manual for exact specifications and fit.