How to Replace Windshield Washer Reservoir 01-06 Hyundai Elantra

Difficulty: Intermediate · About 55 min · Hyundai Elantra

Replace the windshield-washer reservoir on a 2001–2006 Hyundai Elantra by removing the front grille and bumper cover and transferring the pump.

Steps

1. Remove grille and lamp access

   Switch off the ignition and protect the front bodywork. Remove the grille retainers and grille, then disconnect and remove the headlamp and parking lamp as needed for bumper access.

2. Release the bumper cover

   Remove the wheel-well, lower, and lamp-area fasteners. Release the side tabs carefully and pull the cover forward with an assistant, disconnecting any lamp connectors before setting it aside.

3. Remove the washer reservoir

   Place a catch pan below the washer pump and unplug its connector. Release the pump and hose, remove the bottle fasteners, and slide the reservoir out of its mounts.

4. Install the new reservoir

   Transfer the pump and inspect its seal before seating it in the replacement bottle. Mount the reservoir, reconnect the hose and electrical plug, and secure the bottle fasteners.

5. Reassemble and test

   Refit the bumper, lamps, and grille in their original order, confirming all clips are engaged. Fill the bottle with washer fluid, operate the washers, and check for leaks.

Check your vehicle’s repair manual for exact specifications and fit.