How to Replace Front Sway Bar Links 97-00 Toyota Camry
Difficulty: Intermediate · About 90 min · Toyota Camry
Replace front sway-bar links on a 1997–2000 Toyota Camry. Support the vehicle safely, avoid twisting the stabilizer bar, and tighten link hardware to the exact vehicle specification.
Tools you will need
- Floor jack
- Jack stands
- 21mm socket
- 14mm socket
- Ratchet
- Torque wrench
- Locking pliers
Parts and supplies
- Front sway-bar links
Steps
Raise and support the front
Loosen wheel nuts on the ground, raise the front at approved points, and secure it on jack stands. Remove the wheel for access to the stabilizer link.
Remove the old link
Hold the joint stud with locking pliers where provided and remove its upper and lower nuts. Note the link orientation before removing it.
Install the replacement link
Position the new link in its original orientation and start both nuts by hand. Prevent the joint from spinning and tighten fasteners to vehicle specification.
Reinstall the wheel and inspect
Refit the wheel and tighten its nuts in a crossing pattern to specification. Lower the car and check for contact, loose hardware, or new noises during a cautious drive.
Check your vehicle’s repair manual for exact specifications and fit.