How to Replace Rear Upper Control Arm 06-11 Honda Civic
Difficulty: Intermediate · About 90 min · Honda Civic
Replace the rear upper control arm on a 2006–2011 Honda Civic, removing its knuckle and body fasteners before tightening the replacement with the suspension supported.
Tools you will need
- Hammer
- Socket Extensions
- Torque Wrench
- 14mm Socket
- Rust Penetrant
- Jack Stands
- Center Punch
- 19mm Socket
- Ratchet
- Floor Jack
- 1/2 Inch Breaker Bar
Parts and supplies
- Rear upper control arm
- Wheel lug nuts
Steps
Remove the rear wheel
Loosen the lug nuts slightly with the vehicle on the ground. Lift and support the rear on jack stands, remove the lug nuts, and take off the wheel.
Remove the upper arm
Counterhold the knuckle fastener as needed while removing its bolt. Tap the bolt out with a punch if it sticks, then remove the arm's body-side nuts and withdraw the old arm.
Install the replacement arm
Place the new arm in the same orientation and start its body fasteners by hand. Align the knuckle connection, install its bolt, and leave the hardware loose until everything is seated.
Tighten the arm at ride height
Support the suspension with a floor jack to approximate normal ride height. Tighten the knuckle and body-side fasteners to the vehicle's specifications.
Refit the wheel
Install the wheel and start the lug nuts by hand. Snug them evenly, lower the vehicle, and torque the nuts to the vehicle's specification in a crossing pattern.
Check your vehicle’s repair manual for exact specifications and fit.