How to Replace Rear Window Regulator Motor 00-07 Toyota Highlander

Difficulty: Advanced · About 100 min · Toyota Highlander

Replace the rear power window motor on a 2000–2007 Toyota Highlander while supporting the glass and transferring the regulator carefully.

Steps

1. Remove the rear door panel

   Release the door pull and handle trim, remove the panel screws, and lift the panel off its clips. Unplug the window switch and disconnect the interior handle before peeling back the water barrier.

2. Move the run channel and secure the glass

   Release the run channel fasteners and lift the channel out enough to free the glass. Raise the window, support it with tape, unplug the motor, and remove the regulator mounting bolts before guiding the assembly out.

3. Transfer the motor to the regulator

   Mark the motor position on the regulator, remove its Torx screws, and separate the motor. Align the replacement motor to the marks and secure it, then reinstall the regulator and reconnect the motor lead.

4. Reinstall the glass and run channel

   Lower the glass carefully onto the regulator drive and seat it in the run channel. Reinstall the channel fasteners and weatherstrip, reconnect the switch, and test travel before restoring the water barrier.

5. Restore the door trim

   Reconnect the interior handle cables and window switch, then hang and clip the panel into place. Reinstall its screws and trim covers and verify smooth window operation and proper handle release.

Check your vehicle’s repair manual for exact specifications and fit.