How to Replace Exterior Door Handle 98-02 Oldsmobile Intrigue
Difficulty: Intermediate · About 45 min · Oldsmobile Intrigue
Replace the exterior door handle on a 1998–2002 Oldsmobile Intrigue by removing the trim panel, transferring the lock cylinder and latch rod, and restoring the water shield.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- Putty Knife
- T30 Driver
- 10mm Wrench
- 10mm Socket
- Door Panel Removal Tool
- Ratchet
Parts and supplies
- Exterior door handle
Steps
Remove the door panel
Switch off the ignition. Lift out the window-switch panel and unplug the window and mirror connectors. Remove the door-pull Torx screws and handle-bezel screw, release the panel clips, and lift the panel away after disconnecting the lock and speaker wiring.
Remove the original exterior handle
Reconnect the window switch temporarily and raise the glass for access, then unplug the switch again. Peel back the water shield, release the latch rod, remove the two 10 mm handle bolts, and pull the handle outward and off its lock rod.
Transfer the lock cylinder and rod
Release the lock-cylinder clip and transfer the cylinder to the new handle. Reconnect the latch rod to the replacement handle and check that the gasket sits correctly around the mounting surface.
Install and test the handle
Position the replacement handle and reinstall its two 10 mm bolts. Secure the latch rod in its clip, return the water shield, and test the handle with the door unlocked before reinstalling the panel.
Reinstall the door panel
Reconnect the speaker, lock, mirror, and window wiring, then align and press the panel clips into place. Reinstall the screws and trim, and verify the door opens and locks correctly before closing it.
Check your vehicle’s repair manual for exact specifications and fit.