How to Replace Throttle Position Sensor 94-02 Dodge Ram 1500
Difficulty: Beginner · About 20 min · Dodge Ram 1500
Replace the throttle position sensor on a 1994–2002 Dodge Ram 1500 by disconnecting its connector, transferring the sensor, and checking engine response after installation.
Tools you will need
- Socket Extensions
- Ratchet
- T25 Torx Socket
Parts and supplies
- Throttle position sensor
Steps
Disconnect the sensor
Switch off the ignition and locate the throttle-position sensor on the throttle body. Release its electrical connector lock and unplug it, checking for damaged pins or corrosion before proceeding.
Remove the old sensor
Remove the two T25 mounting screws and pull the sensor straight off the throttle body. Note its orientation and inspect the mounting surface for dirt or damage.
Install the replacement sensor
Position the replacement sensor in the same orientation and seat it fully against the throttle body. Start and tighten both T25 screws evenly, then reconnect the electrical plug until its lock clicks.
Verify operation
Start the engine and check for a stable idle and normal throttle response. If a warning light remains or drivability problems continue, scan for diagnostic codes and follow the vehicle's service procedure for sensor calibration if required.
Check your vehicle’s repair manual for exact specifications and fit.