How to Replace Rear Brake Kit 02-04 Honda Odyssey

Difficulty: Intermediate · About 90 min · Honda Odyssey

Renew the rear pads and rotors on a 2002–2004 Honda Odyssey, clean and inspect the caliper slides, then restore pedal pressure before a cautious brake check.

Steps

1. Raise the vehicle and remove a rear wheel

   With the van on level ground, loosen the lug nuts slightly. Lift the rear with a floor jack, support it securely on jack stands, remove the nuts, and take off the wheel.

2. Remove the caliper and pads

   Remove the two caliper guide bolts and lift the caliper away from the bracket. Support it so its hose is not stretched, then slide the old pads out of the bracket.

3. Remove the bracket and rotor

   Unbolt the caliper bracket and set it aside. Loosen the rotor retaining screws with an impact driver, then pull the rotor off the hub; tap it carefully if corrosion holds it in place.

4. Fit the replacement rotor

   Seat the new rotor on the hub and reinstall its retaining screws and access plug. Brush rust from the bracket contact points, check that the slide pins move freely, and lubricate the pins if needed.

5. Install the pads and caliper

   Reinstall the bracket and tighten its fasteners to the vehicle specification. Fit the new pads in their correct positions, compress the caliper piston with a C-clamp, and refit the caliper with its bolts tightened to specification.

6. Refit the wheel and check pedal feel

   Mount the wheel and start every lug nut by hand. Lower the van, tighten the lugs in a star pattern to the vehicle specification, then pump the brake pedal until it feels firm before moving the vehicle.

7. Perform a cautious brake check

   Check for leaks or loose hardware, then test the brakes at walking speed in a clear area. If the pedal feels soft, the vehicle pulls, or any noise is abnormal, stop and inspect the work before driving.

Check your vehicle’s repair manual for exact specifications and fit.