How to Replace Ambient Air Temp Sensor 07-11 Honda CR-V
Difficulty: Intermediate · About 50 min · Honda Cr-v
Replace the outside air temperature sensor on a 2007–2011 Honda CR-V by removing the bumper cover, changing the sensor, and restoring all clips and fasteners.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- 10mm Socket
- Ratchet
- Trim Tool Set
Parts and supplies
- Outside air temperature sensor
Steps
Release the front bumper cover
Switch off the ignition and remove the upper bumper cover retainers. Remove the lower 10 mm fasteners and Phillips screws on both sides, then release the remaining clips along the lower edge and corners. Pull each side outward to free the cover from its guides.
Disconnect the old temperature sensor
Support the bumper cover as it moves forward and unplug any connectors that remain attached. Disconnect the temperature sensor harness and slide the sensor off its bracket without damaging the wiring.
Install the replacement sensor
Slide the new sensor onto the bracket until it is fully retained and reconnect its electrical harness. Check that the wire is routed away from sharp edges and will not be pinched when the bumper is installed.
Reinstall the bumper and verify
Align the bumper with its side guides and press the clips into place. Reinstall the side screws, lower fasteners, and upper retainers, then turn on the ignition and confirm the outside-temperature display responds normally.
Check your vehicle’s repair manual for exact specifications and fit.